You are using an out of date browser. It may not display this or other websites correctly. You should upgrade or use an alternative browser.
lift
A surface lift is a type of cable transport for snow sports in which skiers and snowboarders remain on the ground as they are pulled uphill. While they were once prevalent, they have been overtaken in popularity by higher-capacity and higher-comfort aerial lifts, such as chairlifts and gondola lifts. Today, surface lifts are most often found on beginner slopes, small ski areas, and peripheral slopes. They are also often used to access glacier ski slopes because their supports can be anchored in glacier ice due to the lower forces and realigned due to glacier movement.
Surface lifts have some disadvantages compared to aerial lifts: they require more passenger skill and may be difficult for some beginners (especially snowboarders, whose boards point at an angle different than the direction of travel) and children; sometimes they lack a suitable route back to the piste; the snow surface must be continuous; they can get in the way of skiable terrain; they are relatively slow in speed and have lower capacity.
Surface lifts have some advantages over aerial lifts: they can be exited before the lift reaches the top, they can often continue operating in wind conditions too strong for a chairlift; they require less maintenance and are much less expensive to install and operate.
Considering the BDS 2.5” lift w/ nitro shocks but concerned with eng weight. I also like the OME 2” lift but it is double the price of the BDS. Thoughts and advice welcomed. The jeep gets a little squirrely under power. I recently added power steering and that helped a lot. I think dropping her...
Hi. I installed a Rough Country 2.5" lift kit in my '79 CJ7. Despite the instructions, and original set up, it would not go in axle-over-spring. The front shocks were completely compressed, and sway bar links were too short. So, disassembled and installed spring-over-axle and everything fit...
Hey guys,
My 85 Laredo is all stock but does have a small rake to it. I would like to lift only the front up about 1". What would be the easiest way to accomplish this without doing any major modifications? Thanks