scrambler

In telecommunications, a scrambler is a device that transposes or inverts signals or otherwise encodes a message at the sender's side to make the message unintelligible at a receiver not equipped with an appropriately set descrambling device. Whereas encryption usually refers to operations carried out in the digital domain, scrambling usually refers to operations carried out in the analog domain. Scrambling is accomplished by the addition of components to the original signal or the changing of some important component of the original signal in order to make extraction of the original signal difficult. Examples of the latter might include removing or changing vertical or horizontal sync pulses in television signals; televisions will not be able to display a picture from such a signal. Some modern scramblers are actually encryption devices, the name remaining due to the similarities in use, as opposed to internal operation.
In telecommunications and recording, a scrambler (also referred to as a randomizer) is a device that manipulates a data stream before transmitting. The manipulations are reversed by a descrambler at the receiving side. Scrambling is widely used in satellite, radio relay communications and PSTN modems. A scrambler can be placed just before a FEC coder, or it can be placed after the FEC, just before the modulation or line code. A scrambler in this context has nothing to do with encrypting, as the intent is not to render the message unintelligible, but to give the transmitted data useful engineering properties.
A scrambler replaces sequences (referred to as whitening sequences) with other sequences without removing undesirable sequences, and as a result it changes the probability of occurrence of vexatious sequences. Clearly it is not foolproof as there are input sequences that yield all-zeros, all-ones, or other undesirable periodic output sequences. A scrambler is therefore not a good substitute for a line code, which, through a coding step, removes unwanted sequences.

View More On Wikipedia.org
  1. A

    Build Thread Next Up 1985 CJ8 Scrambler

    Just about 1/2 into a 1985 CJ8 Build. This one was an automatic, so I'm upgrading it to a a IROC 350 and the 700R4 4 speed transmission. Some pictures below, awaiting warmer weather to start again
  2. A

    Members CJs 82 Srambler

    I finished my 1982 Scrambler in 2020, just after receiving my special order JT Gladiator. I was a diehard Scrambler guy and waited for years as they toyed with making a replacement. Purchased a 1984 new when I was in the military and had it shipped to Germany and then drove it to Sicily where I...
Back
Top Bottom