swap

I bought a 1985 CJ seven from a guy who acquired it from someone who passed away. That builder did a lot of custom work. The current owner really had no idea what he was dealing with, and I bought it knowing it had fuel injection, on board air, lockers, 411 gears, and a bunch of other nice mods...

1 have a 1960 CJ6 and i want to go wider axels and 4 wheel disc preferably. I don't want to go 1 ton axels though, im not going to rock crawl but want a wider stance.

I have a 76 cj5 has the amc20 rear differential, I would like to swap it out what is the closest I could do with minimal fabrication.

I recently finished a re gear on my 1976 CJ5 that I’ve been building for some light river crawling. After completion I decided to start changing fluids on the rest of the powertrain and I was greeted by my transmission having at least a half gallon of water in it and no oil. I then decided to...

I have a 80 cj7 with a 304. I’m looking to swap it with a 360. Any intel on sourcing one? Crate motor is preferred but a good core will work. Thanks in advance.

FNG here on this forum. I have had a mostly stock 68 CJ5 with 225 V6 for a while now that I am currently swapping over to a 231 so I can take my time and rebuild the 225 and still have my Jeep running while I do it. This week is the first time in years my Jeep is down for repairs. My Jeep is a...

Hi All, I have a 1981 cj8 and am in the process of restoring it, while I have the body off I am thinking about doing some suspension work, my front springs seem to be a bit flattened so I was thinking about replacing them. I see a lot of people recommend a Yj spring swap and I'm interested but...

I have a 5.3L LS I'll be swapping into my 1979 CJ-7. The front axle is driver drop, high pinion. So far, I see motor mounts from Advance Adaptors and Novak. I assume I'll need the flexibility to bias the engine a little to the passenger side. Any advice about motor mounts I should look at or...

Hey everyone, I recently got myself a Jeep CJ-7 and was wondering if anyone here has any experience or knowledge about engine swaps using modern engines that meet post-Euro 3 standards (european regulations). I'm based in Spain and haven’t been able to find much clear info on the topic so far...

My 83 CJ7 has a straight 6 and I recently threw a rod, the damage was minimum because I stopped almost immediately. But I have decided to do an engine swap for a V8 instead of fixing the 6 and I am wondering the best way to pick other CJ peoples brains on here about the topic. Thanks for your...

Hey all, New to the forum. I have a 79 CJ7 that I'm doing an engine swap from a 304 to a 360. Upon disassembly I noticed my bell housing is junk and need an intact one. Does anyone here have one they would like to get rid of? It has the t150 3 speed trans.

Hi all. Has any one here ever put a 2.5l td 4 cylinder engine from a XJ cherokee into a CJ7? Ideally with manual trans. Thx and merry Xmas.

From what I've read on the net it looks like a striaghtforward swap. Has anyone done it? What could go wrong at each end? -Input shaft could have different splines... I don't know how the transfer case hooks to the trans so I am only assuming that it's the same for both transmissions...