1985 cj7, 4.2 4 spd
1985cj74spd
Jeeper
need help!!!! my 85 will crank but wont fire. replaced coil(msd), distributor(msd), plugs, plug wires and ignition control module(msd),all new wiring. what else could it be?
-
Hello Guest, we are proud to now have our Wiki online that is completely compiled and written by our members. Feel free to browse our Jeep-CJ Wiki or click on any orange keyword when looking at posts in the forum.
1985 cj7, 4.2 4 spd
- Thread starter 1985cj74spd
- Start date Start date:
- Last post Last post:
oss
Jeeper
- Posts
- 123
- Thanks
- 0
- Location
- Temple,Texas
- Vehicle(s)
- 84 CJ-7 258 bored .060, head shaved .040, Weber 34/38,Dana 300 terra low 4:1 D&D Machine stainless twin-stick, D-30 4.10's spartan locker, Model 20 4.10's EZ-locker Moser one piece axles,33" BFG A/T's
Make sure it's getting spark. If the spark is there, then go to the carb and make sure it's getting fuel. Those are the two things needed for combustion along with air. Sometimes new parts can be bad too.
- Posts
- 14,790
- Thanks
- 55
- Location
- Springfield, Missouri-U.S.A. Earth
- Vehicle(s)
- '85 CJ-7, 258/4.2L 6cyl. Bought new in 1985. Full cage, Warn 8274 winch, Ford 9" rear, front/rear Detroit Lockers w/4:88 R&P. T-5 tranny and 4:1 t'case. 33X12.50-15 BFG/AT, MSD ign, on board air---
WELCOME 
How long since it last ran?
Confirm fuel flow to carb when cranking.
Confirm spark to plugs.
What were you doing to the Jeep last?
LG
How long since it last ran?
Confirm fuel flow to carb when cranking.
Confirm spark to plugs.
What were you doing to the Jeep last?
LG