• To celebrate the 4th of July, starting today (07/01/2025) all User Upgrades will be reduced by 10% (thru 07/08/2025) To use this special coupon use the code 2025-4th-10percent at check out. If you are already a supporter your existing package will be extended.
    Thank you for your support!
  • Hello Guest, we are proud to now have our Wiki online that is completely compiled and written by our members. Feel free to browse our Jeep-CJ Wiki or click on any orange keyword when looking at posts in the forum.

Dana 300 Shift linkage

Dana 300 Shift linkage
Greenmule

Greenmule

Jeeper
Posts
48
Thanks
0
Location
Berthoud, Colorado
Vehicle(s)
1981 CJ5 AMC 5.0L, Ramsey 8k winch, Goodyear MTR 35/12.50/15, 2" Body lift, Dana 44 Rear with ARB front and rear air locker, 4:1 Gear Reduction, Warn locking hubs front and rear, front disconnecting sway bar. Power Steering brace. Rock sliders. Acme hard top. TeamRush upgrade using MSD parts. E3 Sparkplugs
My Dana 300 shift linkage rattles so I thought I would replace the damper at the bottom of the linkage. My. question is do I have to remove the Dana 300 to take apart the shift linkage? I assume I would but I thought I would ask those of you who have more experience. Thanks in advance.
 
You can get to it by taking the tunnel cover off, no need in dropping the t/c.
 
Cool, that would be much easier. I should have thought of that. Thanks
 
You must log in or register to reply here.

Jeep-CJ Donation Drive

Help support Jeep-CJ.com by making a contribution.

Help support Jeep-CJ.com by making a contribution.
Goal
$200.00
Earned
$0.00
This donation drive ends in
0 hours, 0 minutes, 0 seconds
  0.0%
Contribute
Back
Top Bottom