• To celebrate the 4th of July, starting today (07/01/2025) all User Upgrades will be reduced by 10% (thru 07/08/2025) To use this special coupon use the code 2025-4th-10percent at check out. If you are already a supporter your existing package will be extended.
    Thank you for your support!
  • Hello Guest, we are proud to now have our Wiki online that is completely compiled and written by our members. Feel free to browse our Jeep-CJ Wiki or click on any orange keyword when looking at posts in the forum.

Harness routing

Harness routing
Y

yellow85cj

Senior Jeeper
Posts
672
Media
3
Resources
1
Solutions
3
Thanks
32
Location
Ft Worth,TX
Vehicle(s)
85 CJ7, 258,4.0 head, T177, D300, Dana 30, AMC 20, 3.54
Trying to put the CJ back together, can't remember and don't have any pics of where the Back up/FWD light harness runs up to the firewall. Left side? Right side? Center? Pics are always nice.:D Appreciate any help.
 
If your talking about the harness that goes to the rear lights (stop, tail, turn, backup) and the fuel pump, mine runs down the drivers side.
 
No that's the easy one. Well, except for the fact that I don't know whether to run it over the e brake or under it. :)

Guess I should have been more specific. The harness that goes from the Dana 300 4WD light switch and the reverse light switch on the T177 to the connector on the firewall side.
 
Comes up on the passenger side of the firewall. Plugs into the main harness just to the right of the battery.
 
You must log in or register to reply here.

Jeep-CJ Donation Drive

Help support Jeep-CJ.com by making a contribution.

Help support Jeep-CJ.com by making a contribution.
Goal
$200.00
Earned
$0.00
This donation drive ends in
0 hours, 0 minutes, 0 seconds
  0.0%
Contribute
Back
Top Bottom