HELP! No Reverse/Brake Lights!
CJ Girl
Jeeper
Hey everyone... pop quiz... I have running lights and turn signals on both sides, but no reverse or brake lights... also my 4wd indicator and horn aren't working. Fuses look ok... any ideas? 
HELP! No Reverse/Brake Lights!
- Thread starter CJ Girl
- Start date
CJKrawler
Old Time Jeeper
You could have several things wrong there. Did everything quit working all at once? If not, you will need to look at them one at a time. The switch for the crake lights is actuated by the pedal, make sure that is making contact. The reverse switch is actuated from the Transmission , check the wiring there.
IOPort51
NOT the voice of reason Jeep-CJ.com
- Posts
- 13,959
- Media
- 422
- Thanks
- 11
- Location
- Garland Texas
- Vehicle(s)
- 1977 cj-5
4.2 W/MC2100 carb, 4.0 head W/3 angle valves,SS Header,TFI ignition with MSB-6 offroad module,CS144 140 amp RPS alternator with remote regulator T-150,d-20,Dana 44 with OX lock and disk brakes. D-30 with Spartin locker,
skyjacker 2.5 lift?nitro shocks,31" BFG A/T off road.8000 lb Warn winch, original owner.=^)
2006 Toyota Tacoma
check the ground back near the tail lights.
I would start with a volt meter and check for voltage to ground at the bulb socket.
I would start with a volt meter and check for voltage to ground at the bulb socket.
CJ Girl
Jeeper
Thanks guys! I'll try your suggestions, and I'll let ya know how I do!
BrockGrimes
Jeep-CJ.com Archive Master
Also a multimeter test of fuses will tell you if they are good, I've seen ones that look it but aren't good.