Knob Removal
Knob Removal
- Thread starter calcj7
- Start date
elwood blues
Always Off-Roading Jeeper
- Posts
- 6,023
- Media
- 71
- Solutions
- 1
- Thanks
- 49
- Location
- Export, PA
- Vehicle(s)
- 1978 CJ7 4.2L Comp Cam & valve train, MC2100 carb, MSD ignition, Dana 30 front, T18 trans, Dana 20 txfr, AMC 20 rear.
Does your new switch have a knob on it? Because the black plastic knobs are molded on to the ends switches and cables, you have to cut them off. I used a razor knife and a pair of needle nose locking channel locks.
IOPort51
NOT the voice of reason Jeep-CJ.com
- Posts
- 13,959
- Media
- 458
- Thanks
- 11
- Location
- Garland Texas
- Vehicle(s)
- 1977 cj-5
4.2 W/MC2100 carb, 4.0 head W/3 angle valves,SS Header,TFI ignition with MSB-6 offroad module,CS144 140 amp RPS alternator with remote regulator T-150,d-20,Dana 44 with OX lock and disk brakes. D-30 with Spartin locker,
skyjacker 2.5 lift?nitro shocks,31" BFG A/T off road.8000 lb Warn winch, original owner.=^)
2006 Toyota Tacoma
I think you just need to pull harder on the switch knob. 
the cables are molded on but I think the wiper switch and heater switch are pull off.
the cables are molded on but I think the wiper switch and heater switch are pull off.
Cheepjeep85
Crazy Sr. Respected Jeeper
- Posts
- 4,934
- Media
- 57
- Thanks
- 0
- Location
- Chickamauga, Ga
- Vehicle(s)
- 1985 Jeep CJ7, 258, t-176, D300, AMC20, D30
it'll pull off, so will the cable ends if you pull em hard enough, i know i had to glue all of mine back on. you can also buy replacement knobs in the factory style, or machined billet aluminum they are pretty nice.
