Looking for a short rope

[driver007]

I pressed on my one piece axle bearings on to the axle. I checked and rechecked pre load 40 thou. I put the first axle in on the passenger side everything seemed good. I put the driver side on and it put the axle into a state of no spin. To much pre load so I will pull the bearing of and check pre load again. Clean and reinstall. What changed on me that would cause this. I used the mic when checking the bearing preload. When you have to tight a bearing on one side can it affect the other side?

 

[Old Dog]

I have to ask. Did you get the bearings and retainers from one of the axle companies or from the auto store?

 

[driver007]

Found out my problem. The thrust block has to be removed. A fact that I did not know. I will pull it and all should be good. I used all g2 stuff