Misc Seperate small Vin plate
Misc Seperate small Vin plate
- Thread starter SFC-81-CJ
- Start date
CJ
Admin
- Posts
- 21,752
- Thanks
- 623
- Location
- Central FL
- Vehicle(s)
- '72 CJ5, 401, T18, D20, D44, D30
'82 CJ8, 258, D300, AMC20, D30
Does it look like this or close? This is a trim plate for different years, but they are all similar. Can you post yours?
Belizean
Always Off-Roading Jeeper
- Posts
- 6,022
- Thanks
- 404
- Location
- New Orleans area
- Vehicle(s)
- 84 CJ7 4 banger-owned since new in 1984 bought off truck at dealership - rebuilding 258, T176 with Sniper EFI D300 4:1 Lomax gears Twin Sticked 1 piece axels with locker
Mine came new with a sticker down low on the body by the driver seat. Been unreadable for a couple of decades
CJ
Admin
- Posts
- 21,752
- Thanks
- 623
- Location
- Central FL
- Vehicle(s)
- '72 CJ5, 401, T18, D20, D44, D30
'82 CJ8, 258, D300, AMC20, D30
I can't remember when they dropped the riveted plates.
- Posts
- 14,772
- Thanks
- 44
- Location
- Springfield, Missouri-U.S.A. Earth
- Vehicle(s)
- '85 CJ-7, 258/4.2L 6cyl. Bought new in 1985. Full cage, Warn 8274 winch, Ford 9" rear, front/rear Detroit Lockers w/4:88 R&P. T-5 tranny and 4:1 t'case. 33X12.50-15 BFG/AT, MSD ign, on board air---
My '85 has both.
The inside one has long faded out.
IIRC, it showed GVWR and such.
The inside one has long faded out.
IIRC, it showed GVWR and such.
Belizean
Always Off-Roading Jeeper
- Posts
- 6,022
- Thanks
- 404
- Location
- New Orleans area
- Vehicle(s)
- 84 CJ7 4 banger-owned since new in 1984 bought off truck at dealership - rebuilding 258, T176 with Sniper EFI D300 4:1 Lomax gears Twin Sticked 1 piece axels with locker
X2. Same here