You are using an out of date browser. It may not display this or other websites correctly. You should upgrade or use an alternative browser.
replacement
Joint replacement is a procedure of orthopedic surgery known also as arthroplasty, in which an arthritic or dysfunctional joint surface is replaced with an orthopedic prosthesis. Joint replacement is considered as a treatment when severe joint pain or dysfunction is not alleviated by less-invasive therapies. Joint replacement surgery is often indicated from various joint diseases, including osteoarthritis and rheumatoid arthritis.Joint replacement has become more common, mostly with knee and hip replacements. About 773,000 Americans had a hip or knee replaced in 2009.
My 82 CJ7 was having issues with starting after it sat for periods of time longer than a half hour. I had to continually pump the accelerator all the way to the floor in order to get it to start. I believed it to be an issue with the carburetor which I have replaced several times prior, so I did...
What is the best fuel to run in my '72 CJ with the 4.2L? I assume ethanol free, but should I use a lead replacement additive or anything else?
This may have been posted previously, but I'll post again just in case... Here's a good link ethanol free gas stations if you are looking for ethanol...
I am in the middle of replacing the stock motorcraft distributor with an HEI setup and taking the opportunity to clean up some wires at the same time.
This Red w/ stripe wire next to the electric choke Red wire is confusing me.
I have a '80 FSM and it's not helpful
I have added a couple...
The original fuse box, located to the left of the clutch pedal, in my 1985 CJ7 is damaged. Is it possible to replace the box without replacing the entire wiring harness? I am a somewhat barely competent amateur mechanic and am trying to determine if this is something I can do myself. The only...
I am wanting to replace my gasket between the bottom of the windshield frame and the body.
Does anyone have a recommendation for a good one, preferably not Omix or Crown. I think mine of so old it has turned hard so I can’t pull my windshield back as far as it should be. It should be 67 ¼ from...