axle flip kit
mudncj
Jeeper
approx. how much lift would you get out of flippin your springs to the top of the axles 4-5 in?
axle flip kit
- Thread starter mudncj
- Start date
LongHorn
Always Off-Roading Jeeper
- Posts
- 5,325
- Media
- 39
- Thanks
- 1
- Location
- Washington Co.,Texas
- Vehicle(s)
- 83'CJ-8 Scrambler Slightly Modified;),48'CJ2A, 54'CJ3B 67'Jeep M-725, 88'YJeep Wrangler Slightly Modified;)
It depends on what axles, springs & shackles, but usually about seven inches.
mylittlecj5
RIP Mike, we'll all miss you
There is a lot more than inverting the spring mounts to making a safe SOA rig, please research this carefully before you start on this. Sometimes, depending on abilities and shop capabilities, its easier and safer to just buy a quality suspension lift. Only you can make that decision, but please don't be "THAT GUY" everyone runs from while you are on the trail, or in the mud...
LongHorn
Always Off-Roading Jeeper
- Posts
- 5,325
- Media
- 39
- Thanks
- 1
- Location
- Washington Co.,Texas
- Vehicle(s)
- 83'CJ-8 Scrambler Slightly Modified;),48'CJ2A, 54'CJ3B 67'Jeep M-725, 88'YJeep Wrangler Slightly Modified;)
I suggest going to high steer arms on any spring over conversion. Usually the steering linkage is the downfall. #2 would be spring wrap.
Hammerhead
Jeeper
- Posts
- 48
- Media
- 5
- Thanks
- 0
- Location
- Ontario, Canada
- Vehicle(s)
- 85 CJ, 95 F350 , 1993 Bronco, 01 Valkyrie, 2 sleds
I got 5.3" out of mine. Made the spring perches myself and kept low.