CJ tie rod thread size
CJ tie rod thread size
- Thread starter IrishCJ6
- Start date
Old Dog
Always Off-Roading Jeeper
- Posts
- 13,886
- Media
- 82
- Thanks
- 5
- Location
- Stonelick Lake, Ohio
- Vehicle(s)
- 83 CJ7 350 tbi, TH350, D300 twin sticked & clocked, narrowed Chief D44 Eaton Elocker & Moser shafts, Explorer 8.8 Detroit locker, 410's, RE 4.5" spring lift 1" body lift, 35" Claws, cage tied to frame, Corbeau baja seats, HD tie rod and draglink, u-bolts flipped, custom skid plate and sliders, Warn 9.5ti winch with Amsteel synthetic line
My 83 is 11/16-18. I'm not 100% your 75 is the same, but I think it is.
I used 1.25" DOM with .625 Id.(which is the tap drill size) for mine.
I used 1.25" DOM with .625 Id.(which is the tap drill size) for mine.
Last edited:
PaRenegade
Crazy Sr. Respected Jeeper
- Posts
- 3,055
- Media
- 20
- Thanks
- 5
- Location
- Lewistown, Pa.
- Vehicle(s)
- 1982 Jeep CJ-7 Renegade
258, T-4, D300, trussed AMC20 w/Detroit & 1pc., Dana30 w/TrueTrac, 3.73:1; just finished a restomod
I thought most tie rod ends were standardized with a 5/8" end and the 1 ton and overs used a 7/8" end. I may be mistaken.
- Posts
- 4,551
- Media
- 1
- Thanks
- 6
- Location
- california
- Vehicle(s)
- 1965 CJ-5 Buick V6 Ford T-18 4-Speed Spicer 20/18,Warn Overdrive Dana 30 & 44 w/Powr-Lok posi / both,4.27 gears 33" tires.
11/16 x18 is correct for a 1975.........both Left & Right hand thread. And most one ton TRE are 7/8" thread.