Flexible Brake Lines
- Posts
- 7,316
- Media
- 5
- Solutions
- 1
- Thanks
- 157
- Location
- Roanoke, Va
- Vehicle(s)
- '80 CJ-7, AMC 304, T177, Dana 300, Widetrack axles (D30 & AMC20) w/ 3.73 gearing, MSD ignition,
I’m ready for new brake lines - originals were rusty inside and out. Any reason I can’t / shouldn’t run flexible lines from the master cylinder to the proportioning valve? I have a flexible line at the rear axle and at each wheel. If I run hard lines I will be the one bending and fitting, and I’m not looking forward to the pigtail section. Flexible lines would make my life easier.......
Sent from my gas grille using Tapatalk
Sent from my gas grille using Tapatalk