Need help, I only have 2 guages working, after engine swap

Need help, I only have 2 guages working, after engine swap

bdunnam

Jeeper
Posts
191
Thanks
0
Location
New Albany Ms
Vehicle(s)
'86 CJ7 Laredo Black 4.2l i6
Everything I unhooked under the hood is wired back up with the exception of the ignition module, because of the HEI distributor. It seems like im missing some sensors that plug in the manifold. I dont remember cutting any wires except for one that I assume grounds on the top of the bellcrank, behind the carb, and now i cant remember what color the wire was. If anyone can post a pic of the bellcrank area on the top side of the intake manifold, and possibley where that wire runs would be greatly appreciated.
 

Jeep-CJ Donation Drive

Help support Jeep-CJ.com by making a donation.

Help support Jeep-CJ.com by making a donation.
Goal
$200.00
Earned
$10.00
This donation drive ends in
Back
Top Bottom
AdBlock Detected

I get it, I'm a Jeep owner and ad-block detectors kinda stink but ads are needed on this site. This is a CJ site, all the ads are set for autos (some times others get through.) I cannot make them just for Jeeps but I try.

Please allow ads as they help keep this site running by offsetting the costs of software and server fees.
Clicking on No Thanks will temporarily disable this message.
I've Disabled AdBlock    No Thanks