Paint
Dlowe
Jeeper
I've decided to go with flat black for the exterior color. Enamel? Was lacquer used originally? I'm assuming you can wet sand/blend enamel just like lacquer? Any suggestions, experience, advise would be appreciated.
Paint
- Thread starter Dlowe
- Start date
rr41mag
Full Time Jeeper
- Posts
- 2,015
- Thanks
- 1
- Location
- Panama city florida
- Vehicle(s)
- 04 dodge truck, 1966 chevy truck, 2012 rav4
And finally a 1981 jeep cj7 258 hardtop
Don't you wet sand to slick the paint and geta glossy finish? We painted aircraft with flat paint and it was rough. You really can't get much laquer any more. Most all paints are enamel
coldair
Full Time Jeeper
Go to eastwood.com to buy your paint pretty good paint and a good deal too. I've got alot of body stuff from them. That's where I'm going to get my rat rod flat black. Been told they have a clear coat that makes it so you can keep it your paint flat.
johnbilt
Jeeper
- Posts
- 245
- Thanks
- 1
- Location
- Alaska
- Vehicle(s)
- 1973 CJ5 - AMC360 /EB Performer intake / Isky Cam / Holley Carb - T18 - D20 w/2.41 Low - 4.56 Locker Rear and Front Pwr-Lok.
I used PPG products on mine. The urethane is a tough paint. Not certain about the flat finish though. The paint store will know....