transfer case shift lincage adjustment
ftwflh
Senior Jeeper
- Posts
- 664
- Thanks
- 0
- Location
- Crossville,IL
- Vehicle(s)
- 1976 CJ 5, 232 6cyl 3spd lots of rust,good frame,Dana 44s w/373 gears,ProComp 4in lift kit
-
Hello Guest, we are proud to now have our Wiki online that is completely compiled and written by our members. Feel free to browse our Jeep-CJ Wiki or click on any orange keyword when looking at posts in the forum.To dismiss this noticeclick the top right X.
transfer case shift lincage adjustment
- Thread starter ftwflh
- Start date Start date:
- Last post Last post:
Purple77CJ7
Full Time Jeeper
- Posts
- 2,797
- Media
- 36
- Thanks
- 2
- Location
- Loveland, Colorado
- Vehicle(s)
- 1977 CJ 7; Amc 401 .30 over, Howell TBI, modified Dana 20 with Terra Low gears and twin sticks, NV 4500 5-speed, modified Dana 30 and Amc 20 both with 4.56 gears (narrow track), ARB air lockers front and rear, SSBC rear disc brake conversion, MICO Brake park brake, Navaho brake booster/ master cylinder, PowerTank CO2 tank.
Just out of curiosity are you using a single lever? The reason I ask is mine was hitting the floor sheet metal when the body and frame flexed. That would pop it out of low range some of the time.
Sasquach
Crazy Sr. Respected Jeeper
- Posts
- 4,054
- Media
- 35
- Thanks
- 2
- Location
- Santa Ynez, Ca.
- Vehicle(s)
- 1978 CJ5, 258 w/4.0head, Mopar MPI, P.S., P.B.,Tilt wheel, No stereo, t-18, t-20, amc 20, dana-30 w/tru-trac, Warn full float w/locking hubs & Detroit locker in the AMC.
1964 CJ3B, 4-134
1952 M100 trailer
In line with what Purple said, do you have a T case drop? Same issue will occur with the lever running out of travel into the cutout or the boot being to stressed .
ftwflh
Senior Jeeper
- Posts
- 664
- Thanks
- 0
- Location
- Crossville,IL
- Vehicle(s)
- 1976 CJ 5, 232 6cyl 3spd lots of rust,good frame,Dana 44s w/373 gears,ProComp 4in lift kit
I do have a drop .I will look at the clearance .Thanks