Trim for headers
-
Hello Guest, we are proud to now have our Wiki online that is completely compiled and written by our members. Feel free to browse our Jeep-CJ Wiki or click on any orange keyword when looking at posts in the forum.
Trim for headers
- Thread starter waldroup4516
- Start date Start date:
- Last post Last post:
Saddle Tramp
Full Time Jeeper
- Posts
- 1,687
- Thanks
- 2
- Location
- Vancouver, USA
- Vehicle(s)
- 1978 CJ5, AMC 401, CJ T18, Scout Dana 300, 2-1/2" Lift, Locked
Sawzall
BusaDave9
Always Off-Roading Jeeper
- Posts
- 8,248
- Featured
- 3
- Media
- 361
- Resources
- 2
- Thanks
- 88
- Location
- Durango, Crawlarado
- Vehicle(s)
- 1979 Jeep CJ5 with 304 V8, T18 Transmission, Dana 20 Transfer case with TeraLow 3:1 gears, 4.88 axle gears, Detroit Locker up front and Ox Locker in back with 1 piece axle shafts, 36" SuperSwamper SX Tires, Shackle reversal, MileMarker Hydraulic winch, MSD 6A ignition.
Nneumatic Shears are the best way to cut curves.
Pneumatic Tools
An angle grinder with a cutting wheel can also be used but it's harder to make a curve. Same can be said for a reciprocating saw.
An angle grinder with a cutting wheel can also be used but it's harder to make a curve. Same can be said for a reciprocating saw.