• Hello Guest, we are proud to now have our Wiki online that is completely compiled and written by our members. Feel free to browse our Jeep-CJ Wiki or click on any orange keyword when looking at posts in the forum.
    To dismiss this notice
    click the top right X.

What throwout bearing and fork to use?

What throwout bearing and fork to use?
K

kovacjr

Jeeper
Posts
48
Thanks
0
Location
NJ
Vehicle(s)
02 Silverado Z71 5.3

72 CJ5 304, 3sp, 2.5" lift, 33x12.5
I have done a 360 swap along with a ford T-18 . I have the short bellhousing to match up with the Transmission to the AMC. Question is I had a bearing that came with the clutch. the clutch is the right one for the ford to amc. My orignal fork was a clip in bearing and that was asked when I bought the clutch Problem is the bearing is now shot and the fork is loose, hard to shift. Fork now has lots of vertical play. I had bought a new fork when I was converting but it was for a round GM style bearing. Im luckey to have 200 miles since it was reassembled. It seems as though the fork is still just catching a little bit with the the pedal released.

SO how do I figure out what to use for the correct bearing and fork?
 
You must log in or register to reply here.

Jeep-CJ Donation Drive

Help support Jeep-CJ.com by making a contribution.

Help support Jeep-CJ.com by making a contribution.
Goal
$200.00
Earned
$40.00
This donation drive ends in
0 hours, 0 minutes, 0 seconds
  20.0%
Contribute
Back
Top Bottom