case

I've had my 3 speed manual transmission rebuild but I'm missing what looks like a freeze plug where the 4x4 shifter linkage goes into the transfer case. It was missing before it was rebuilt so I'm not sure if anything goes there. Can anyone advise? Thanks. Cory

Hey fellow jeep people. I got myself a 1978 CJ5 that was a full on mudder by the people I purchased it from. They said the clutch was out, but everything else is good. I have the transmission and transfer case out (still mated) and am cleaning the mud off of it before installing the new throw...

Refilling my 1984 CJ7 Dana 300 transfer case and Dana 30 front diff. Looks like I need a GL4, NOT GL5 gear oil (75w90 or 80w90) to fill both (no Limited Slip additive). (Apparently if it is GL5 rated it has brass corrosive sulfer in it.) I cant seem to find any that isn't also GL5 rated...

I have a Dana 20 transfer case which I have been rebuilding. Just about got it all back together to find out I am missing the front output shaft spacer part # J0942112. Is there anybody on here that would have one for sale or can at least send me the measurements so I can get one made. Thanks

Hi everybody, our new-to-us 1970 CJ Orangey has no emergency brake components from the inside handle bracket all the way to wherever. I respectfully request some feedback on the photo: Is this case set up for the emergency brake drum setup, or would the e-brake be inside the rear drum brakes...

Hello everyone! 1st post since just getting the father in-laws 78 cj 7 renegade, so please bear with me. It has a issue with the t-case that gets bound up when trying to get it out of 4 hi/lo. it has a noise that sounds like 2 gears are rubbing together. Just kinda like barely trying to...

Can any of you more knowledgable mechanics POSITIVELY identify this Transfer case simply from the photograph? I "think" it is a Dana 20, but if i could be certain without removing the TC, It would be helpful. It is in a Jeep 1975 CJ5 V8, which i "think" is a 304, and which i "think" has a T150...

My t20 transfer case in my 79 CJ7 is worn and I'd like to rebuild it. I would also like to increase the gear ratio. Any pointers as to who to go to for the parts needed for this? I have an email into Novak, but am looking for other leads as well.