4-134 f head
buddhistguy
Jeeper
- Posts
- 6
- Thanks
- 0
- Location
- Ft Collins, CO
- Vehicle(s)
- I have a 66 CJ5. It has a 4-134 f head, t90c 3 speed transmission, Spicer 18 transfer case, Dana 27 front axle, and Dana 44 rear axle.
-
Hello Guest, we are proud to now have our Wiki online that is completely compiled and written by our members. Feel free to browse our Jeep-CJ Wiki or click on any orange keyword when looking at posts in the forum.
4-134 f head
- Thread starter buddhistguy
- Start date Start date:
- Last post Last post:
Sasquach
Crazy Sr. Respected Jeeper
- Posts
- 4,054
- Media
- 35
- Thanks
- 2
- Location
- Santa Ynez, Ca.
- Vehicle(s)
- 1978 CJ5, 258 w/4.0head, Mopar MPI, P.S., P.B.,Tilt wheel, No stereo, t-18, t-20, amc 20, dana-30 w/tru-trac, Warn full float w/locking hubs & Detroit locker in the AMC.
1964 CJ3B, 4-134
1952 M100 trailer
That engine only puts out 76+-hp when everything is right so 50-55 mph is at the top of it's capability. Great little engine for off the highway use but never gona be a freeway rig, as for the miss start with the obvious tune up stuff-plugs-wires-points-etc.
I had mine completely rebuilt and because of bore condition went to .050 over and it runs great, only a few miles put on it yet and no speed runs (lol) but 55 mph is possible.
I had mine completely rebuilt and because of bore condition went to .050 over and it runs great, only a few miles put on it yet and no speed runs (lol) but 55 mph is possible.
Bob dag
Jeeper
Does yours have the governor? What rpm? Gears?
Similar threads
-
Question
Reply's are voted
on for best answer
-
Question
Reply's are voted
on for best answer
-
Question
Reply's are voted
on for best answer
Engine
5.3L LS Header Question
