700r4

700r4

Tugger

Jeeper
Posts
15
Thanks
0
Location
North West Missouri
Vehicle(s)
1985 CJ7 with a shot 2.5 four banger and a 4 speed. All original and bone stock.
Has anyone on here put a GM 700R4 tranny in a Jeep or ever seen one in a Jeep? I'm planning on putting A 700R4 behind a 350 Pontiac in my 85 CJ7. I already know all of the problems and fixes for the transmission, I'm just wondering about drive line angle and leingth. I'm only lifting it 2" if that helps. Oh and I'm putting the Dana 300 case on the end of the tranny.
 
Has anyone on here put a GM 700R4 tranny in a Jeep or ever seen one in a Jeep? I'm planning on putting A 700R4 behind a 350 Pontiac in my 85 CJ7. I already know all of the problems and fixes for the transmission, I'm just wondering about drive line angle and leingth. I'm only lifting it 2" if that helps. Oh and I'm putting the Dana 300 case on the end of the tranny.

Just curious, how are you going to get the 700 bolted up to a pontiac ?

Id start here:

http://www.jeep-cj.com/forums/f98/attempting-350-sbc-700r4-np208-cj7-1420/
 
There is an adapter plate on the market for this. As for the torque converter, it'll bolt directly to the Pontiac flex plate.
 

Jeep-CJ Donation Drive

Help support Jeep-CJ.com by making a donation.

Help support Jeep-CJ.com by making a donation.
Goal
$200.00
Earned
$110.00
This donation drive ends in
Back
Top Bottom
AdBlock Detected

I get it, I'm a Jeep owner and ad-block detectors kinda stink but ads are needed on this site. This is a CJ site, all the ads are set for autos (some times others get through.) I cannot make them just for Jeeps but I try.

Please allow ads as they help keep this site running by offsetting the costs of software and server fees.
Clicking on No Thanks will temporarily disable this message.
I've Disabled AdBlock    No Thanks