Anybody done or seen this idea?
-
Hello Guest, we are proud to now have our Wiki online that is completely compiled and written by our members. Feel free to browse our Jeep-CJ Wiki or click on any orange keyword when looking at posts in the forum.
Anybody done or seen this idea?
- Thread starter kickitandholdit
- Start date Start date:
- Last post Last post:
neep
Jeeper
- Posts
- 32
- Thanks
- 0
- Location
- bundaberg QLD Australia
- Vehicle(s)
- 85 cj7 amc 360, auto, dana 300, nissan diffs, arb lockers, 37 mtr, custom long arms
All up it will cost about $8000.00. I think it may cost you in the US a bit less as I buy most of my parts from the US and ship them to Australia. The hole buggy has is my work and design I hope it works as it has a lot of new ideas I like to do new stuff but some work some do not
neep
Jeeper
- Posts
- 32
- Thanks
- 0
- Location
- bundaberg QLD Australia
- Vehicle(s)
- 85 cj7 amc 360, auto, dana 300, nissan diffs, arb lockers, 37 mtr, custom long arms
sorry it has been so long but its up and runing still have to pant it and a few small thing,
just a few pics
just a few pics
CJ
Admin
- Posts
- 26,068
- Featured
- 3
- Media
- 881
- Resources
- 193
- Solutions
- 60
- Thanks
- 1,058
- Location
- Central FL
- Vehicle(s)
- '72 CJ5, 401, T18, D20, D44, D30
'82 CJ8, 258, D300, AMC20, D30
BusaDave9
Always Off-Roading Jeeper
- Posts
- 8,246
- Featured
- 3
- Media
- 361
- Resources
- 2
- Thanks
- 91
- Location
- Durango, Crawlarado
- Vehicle(s)
- 1979 Jeep CJ5 with 304 V8, T18 Transmission, Dana 20 Transfer case with TeraLow 3:1 gears, 4.88 axle gears, Detroit Locker up front and Ox Locker in back with 1 piece axle shafts, 36" SuperSwamper SX Tires, Shackle reversal, MileMarker Hydraulic winch, MSD 6A ignition.
Sweet!
Nice buggy. Rear engine gives great visibility.
That looks like some excellent fabrication there.
What kind of suspension? Are you going to use coil-overs? It looks pretty low now without springs.
Good job!
neep
Jeeper
- Posts
- 32
- Thanks
- 0
- Location
- bundaberg QLD Australia
- Vehicle(s)
- 85 cj7 amc 360, auto, dana 300, nissan diffs, arb lockers, 37 mtr, custom long arms
thanks the buggy is set up to go slow top speed ia about 30mph,the air bag is for suspension the rams you see on the diffs one is for steering the 2nd one is to control articulation front and rear are the same the transfer of oil keep the buggy level, it can also be powered so you lean into a hill if needed
neep
Jeeper
- Posts
- 32
- Thanks
- 0
- Location
- bundaberg QLD Australia
- Vehicle(s)
- 85 cj7 amc 360, auto, dana 300, nissan diffs, arb lockers, 37 mtr, custom long arms
hope a few pic can show how it works
Similar threads
-
Question
Reply's are voted
on for best answer
