Do I need a drop pitman arm?
-
Hello Guest, we are proud to now have our Wiki online that is completely compiled and written by our members. Feel free to browse our Jeep-CJ Wiki or click on any orange keyword when looking at posts in the forum.
Do I need a drop pitman arm?
- Thread starter defibvt
- Start date Start date:
- Last post Last post:
CJ
Admin
- Posts
- 23,561
- Featured
- 4
- Media
- 881
- Resources
- 193
- Solutions
- 50
- Thanks
- 864
- Location
- Central FL
- Vehicle(s)
- '72 CJ5, 401, T18, D20, D44, D30
'82 CJ8, 258, D300, AMC20, D30
Wow, definitely need a dropped pitman arm. You need to measure your steering to get the drop. Also need to be sure of the spline count and diameter of the output shaft of the steering box (in case it was replaced.) Make sure the tie rod taper matches the arm.
If it is all stock it should be a bolt on.
If it is all stock it should be a bolt on.
caveman
Full Time Jeeper
- Posts
- 1,700
- Solutions
- 1
- Thanks
- 63
- Location
- Central Maine
- Vehicle(s)
- 88 YJ with a CJ nose, 4.7 Stroker, AW4 transmission, Dana 35 HP front Ford 8.8 rear
I have 4" s Superlift. As the title asks, is drop pitman arm in my future. Where do I get one if needed.
Sent from my SM-G965U using Tapatalk
The pitman arm from a Grand Cherokee is the same as the pitman arms that come with 4 inch lift kits and are a direct bolt on. Most any jeep hardware shop should also have them.
caveman
Full Time Jeeper
- Posts
- 1,700
- Solutions
- 1
- Thanks
- 63
- Location
- Central Maine
- Vehicle(s)
- 88 YJ with a CJ nose, 4.7 Stroker, AW4 transmission, Dana 35 HP front Ford 8.8 rear
I believe it will. At some point they changed to a different steering box and I don't know when that was. Earlier ones should fit. I have no Idea how much drop the XJ arm has.
Peanut Butter
Full Time Jeeper
- Posts
- 2,591
- Media
- 37
- Resources
- 1
- Thanks
- 15
- Location
- Boerne, Texas
- Vehicle(s)
- 1979 Jeep CJ7 TH400 Automatic 258 I6 Quadratrac Amc 20 rear & Dana 30 front, 32 x 11.5 x 15 tires. Currently a Complete Custom Rebuild in progress.
Also I own a 2001 Jeep Cherokee, White, all stock with 4.0L. automatic, and police package. Best part of that is it came with leather seats! This package also has the NP242 Transfer Case, 8.25 rear end, and trailer towing package.
The goal here is to make the two bars as parallel as possible.
I would also check you camber. That might have been overlooked too. There are several good articles on this site related to this subject.
I would also check you camber. That might have been overlooked too. There are several good articles on this site related to this subject.
Similar threads
-
Question
Reply's are voted
on for best answer
-
Question
Reply's are voted
on for best answer
-
Question
Reply's are voted
on for best answer
