Build Thread First Jeep 1984 CJ7 Laredo, Midland, TX

[KRUPP]

The shop sounds nice. When I retire and cash out my ESOP account, that's on the list to have one of those spaces too.


These studs work?

https://www.summitracing.com/parts/oer-1253573?seid=srese2&ppckw=pmax-msn-restoration&utm_source=bing&utm_medium=cpc&utm_campaign=Performance+Max+-+Restoration&utm_term=2329452822989136&utm_content=Performance+Max+-+Restoration

 

[robandhooch]

You can’t take the old ones out of the old unit ? Then swap them into the new part ? Also that garage area is going to be really nice.

WELL... that would have been the avenue, but time between taking apart and having bandwidth and in the cluster of a move moving the bench to the shop have put a damper on that. I'm going to look for the originals at the shop, but not holding out hope.

 

[robandhooch]

The shop sounds nice. When I retire and cash out my ESOP account, that's on the list to have one of those spaces too.


These studs work?

https://www.summitracing.com/parts/oer-1253573?seid=srese2&ppckw=pmax-msn-restoration&utm_source=bing&utm_medium=cpc&utm_campaign=Performance+Max+-+Restoration&utm_term=2329452822989136&utm_content=Performance+Max+-+Restoration

They look good, but my memory is a bit off on which side is the outside facing part of the stud, if it's the long bit that may just fit the bill. The ones those guys put on it remaning it are maybe 3/4" long but essentially and up flush with the back of the bracket. I'll order a set just in case i can't find the originals.

Good looking out thanks for the link!

 

[CJ]

It's hard to tell, but these may be longer.

https://www.summitracing.com/parts/oer-1253574?srsltid=AfmBOopq3ocSfPxG37XAeds48ujSs0-Xx32I2QKIOstRDBjhK0VzDL1y

 

[robandhooch]

It's hard to tell, but these may be longer.

View attachment 107288

https://www.summitracing.com/parts/oer-1253574?srsltid=AfmBOopq3ocSfPxG37XAeds48ujSs0-Xx32I2QKIOstRDBjhK0VzDL1y

Sure looks it, better picture to see dimension if anything. Well hold my beer boys... sending it. I'll get measurements off them when they come in with thread pitch as well

 

[CJ]

Some basic dimensions are on the notes. But they may just be regular length and chrome plated.

Notes:
Includes two studs 3/8-16 thread and one bolt 3/8-16 thread. Fits most Saginaw and Saginaw P Series pumps. This set is the chrome plated set for use with chrome reservoir.