Engine How to remove a flywheel?
-
Hello Guest, we are proud to now have our Wiki online that is completely compiled and written by our members. Feel free to browse our Jeep-CJ Wiki or click on any orange keyword when looking at posts in the forum.
Engine How to remove a flywheel?
- Thread starter jsimeroth
- Start date Start date:
- Last post Last post:
CJ
Admin
- Posts
- 23,241
- Featured
- 5
- Media
- 881
- Resources
- 193
- Solutions
- 48
- Thanks
- 840
- Location
- Central FL
- Vehicle(s)
- '72 CJ5, 401, T18, D20, D44, D30
'82 CJ8, 258, D300, AMC20, D30
It depends on if the engine is in the Jeep or not but the end result is the same.
You have to pull the Transmission or engine then just unbolt the flywheel.
Basically, disconnect battery, block wheels pull drive shafts, prop up engine (oil pan or strap), support Transmission and Transfer Case , remove crossmember, remove 4 bolts from Transmission to bellhousing, pull Transmission assembly, remove clutch linkage, pull starter, remove bellhousing, unbolt pressure plate then remove flywheel.
Some more info on why would help (is the body on etc.).
You have to pull the Transmission or engine then just unbolt the flywheel.
Basically, disconnect battery, block wheels pull drive shafts, prop up engine (oil pan or strap), support Transmission and Transfer Case , remove crossmember, remove 4 bolts from Transmission to bellhousing, pull Transmission assembly, remove clutch linkage, pull starter, remove bellhousing, unbolt pressure plate then remove flywheel.
Some more info on why would help (is the body on etc.).
Project86
Old Time Jeeper
- Posts
- 1,085
- Thanks
- 50
- Location
- Tx Gulf Coast
- Vehicle(s)
- 1986 CJ 7 Blue
2004 Chevy LWB CC,
2012 Corvette Grand Sport
1986 CJ 7 Red Garnet
1978 CJ 7 Kinda Orangish
Impact is your friend.
- Posts
- 2,167
- Featured
- 1
- Media
- 188
- Solutions
- 11
- Thanks
- 626
- Location
- Thurmont MD
- Vehicle(s)
- 85 CJ7 4.2L 258 .040 over, T-5 trans, dana 300, dana 30 front 3.23 and lock right locker, rear amc 20 3.23 one piece axle shafts traclock
79 CJ7 304, th400 auto borgwarner 1389?? qudratrac stock rest unknown.
89 YJ 4.2L 258, AX-15 5spd, NP231, dana 30 front, dana 35 rear with posi, gears unknown
92 YJ 4.0, AX-15 5spd, np231, dana 30 front, dana 35 rear.
I typically separate the Transfer Case from the Transmission for weight reasons. Then leave the bell housing attached to the Transmission .
Sent from my E7110 using Tapatalk
Sent from my E7110 using Tapatalk