Motorcraft Distributor Alignment Tab
Turbogus
Old Time Jeeper
- Posts
- 1,232
- Thanks
- 2
- Location
- Albany, OR
- Vehicle(s)
- '78 CJ 5 Renegade (Black Betty) Motor AMC 360, T150 trans, 20 tc, Dana 30 front and Dana 44 rear w/posi
'96 GMC K1500 Suburban (Big Blue Basterd) fully loaded with over $10k in options
Howdy all, I fell off the forum forum for a while, life intervenes.
In preperation for the "Team Rush" upgrade I recently purchase the MSD Adapt-a-Cap 8414. The Motorcraft distributor on my 360 has a set screw hole for the Alignment Tab. I've noticed this on one of JeepHammers' excellent threads. I'm fabbing up a cable clamp to serve as the tab but can anyone tell me what the thread and pitch of that set screw is?
it's pretty tiny but seems to have a coarse thread.
I picked up some #6 #8 and #10 machine screws at the local hardware but I'm doubtful that these'll do the trick.
Thanks and a lift of the lynch lid


In preperation for the "Team Rush" upgrade I recently purchase the MSD Adapt-a-Cap 8414. The Motorcraft distributor on my 360 has a set screw hole for the Alignment Tab. I've noticed this on one of JeepHammers' excellent threads. I'm fabbing up a cable clamp to serve as the tab but can anyone tell me what the thread and pitch of that set screw is?
it's pretty tiny but seems to have a coarse thread.
I picked up some #6 #8 and #10 machine screws at the local hardware but I'm doubtful that these'll do the trick.
Thanks and a lift of the lynch lid

