Pilot Bushing?
wilsonasantos10
Jeeper
- Posts
- 38
- Thanks
- 0
- Location
- Spring, Texas
- Vehicle(s)
- 1975 CJ5, 304, 3-speed T15, D20 xfer case, D30 front, D44 rear, 5" lift on 35's,
See photo. I pulled my T-15 Transmission out yesterday with the intent of rebuilding it as well as replacing the throwout bearing, and naturally one project leads to another...it appears as if the pilot bushing fell out when I pulled the Transmission out.
I'm thinking I'll have to pull the bellhousing, pressure plate, and clutch in order to replace this $5 bushing. Any recommendations?? The three bolts on the top of the bellhousing are impossible to access even with a swivel socket...I may have to cut some holes in the tub and plug them later.
I'm thinking I'll have to pull the bellhousing, pressure plate, and clutch in order to replace this $5 bushing. Any recommendations?? The three bolts on the top of the bellhousing are impossible to access even with a swivel socket...I may have to cut some holes in the tub and plug them later.
