Misc. Rim bore size 82 CJ5
-
Hello Guest, we are proud to now have our Wiki online that is completely compiled and written by our members. Feel free to browse our Jeep-CJ Wiki or click on any orange keyword when looking at posts in the forum.
Misc. Rim bore size 82 CJ5
- Thread starter joeortego
- Start date Start date:
- Last post Last post:
TSB8C
Old Time Jeeper
- Posts
- 1,027
- Featured
- 11
- Media
- 26
- Resources
- 1
- Solutions
- 24
- Thanks
- 536
- Location
- Cut-n-Shoot, TX
- Vehicle(s)
- 1984 CJ7, 420 HP "ZZ6 EFI" Crate engine, 700R4, D300, Dana30 front, Dana489 rear, 4.56 gears, 4" lift
108mm is correct. My '84 CJ7 has the Dana 30 front and did have the AMC20 in the rear (swapped that out though). My wheels are Ultra Motorsports #174-5185GN "Nomad 174" series, 15"x10" size. They have a center bore of 108mm and fit perfectly. When I built my matching trailer, I couldn't find those same "Nomad" wheels to match, but I wanted the trailer wheels and the Jeep wheels to be interchangeable (could use a trailer wheel as a spare on the Jeep, or the Jeep spare on the trailer, in a pinch if necessary). So I ordered an axle with hubs that have the same size and stud spacing, but while the trailer has the same tires as the Jeep, I purchased some generic black steel wheels of the same size (diameter, width, and bore) so they would still fit wherever I needed them. Re-reading all that, I realize I've over answered the question. 
But here's a shot from wheel-size.com:
But here's a shot from wheel-size.com:
