Roll Cage Help

[BigDsCJ7]

I just relocated from CT to AZ and I'm looking for a good fab shop to do a full roll cage. Does anyone know a good place to start? I would like it to be near the Phoenix area because I live in Scottsdale. Thank you for the help!

 

[Torxhead]

Custom fabrication can really cost. There used to be outfits that would sell pre bent and cut front bar and spreaders that a weld shop can install relativly inexpensive, or a junk yard might have one. Unless you are looking for a real customized one. I would think you could easily enough find something in a local phonebook.

 

[tarry99]

I just relocated from CT to AZ and I'm looking for a good fab shop to do a full roll cage. Does anyone know a good place to start? I would like it to be near the Phoenix area because I live in Scottsdale. Thank you for the help!

Call Ballistic Fab.............there in Tucson,AZ 520-888-1438 a 1/2 hour south of Phoenix............There into building parts for the 4-wheel drive community but are well connected and I'm sure can steer you in the right direction for your needs. Good People talk to there tech department.

 

[rocmoc]

Try this site, ridingarizona.com

rocmoc n AZ/Mexico

 

[CJ007]

Check out Virtual Jeep Club its the largest local club and there are great fabricators that sponsor.

I am not trying to take away from here as this is the best tech for CJs and a great site but locally Azvjc is the best for that type of info and local runs.

 

[BigDsCJ7]

Thank you guys! And I'm looking into (D)....All the above. I'm also posting about a steering issue....