wheel housing
thistle3585
Senior Jeeper
- Posts
- 722
- Thanks
- 0
- Location
- IN
- Vehicle(s)
- 1979 Jeep CJ5 with '72 304 V8, MC2100carb,T150 trans, AMC20 rear diff with locker, Dana 30 front diff, Dana 20 Tr Case, Procomp Springs, Gabriel Ultra shocks.
The PO cut a strip out of the top of my rear wheel housing on the drivers side possibly to mount something but not sure what. I want to patch it but there are two ribs that run down the wheel housing and if I put flat steel in there then I'll have a 3" gap without the ribs. What would be the best way to do this? My only local salvage yard just shut down and crushed all their jeeps, so I don't have a source to cut a replacement piece from. Any ideas?