• Hello Guest, we are proud to now have our Wiki online that is completely compiled and written by our members. Feel free to browse our Jeep-CJ Wiki or click on any orange keyword when looking at posts in the forum.
    To dismiss this notice
    click the top right X.

Wiring of ballast resistor

Wiring of ballast resistor
C

cityjack

Jeeper
Posts
31
Thanks
0
Location
Willis, VA
Vehicle(s)
82 CJ5 258 4 spd. No mods
Good morning all,

I just got done putting the AMC 258 i6 / 4.2l back in my 82 CJ5 after replacing a tranny seal. The wiring from who I got it from was kind of rigged but the motor and all electrical was working fine. In my haste I did not label the ballast resistor wires when removing the engine. One of the wires to the ballast is still connected to the coil if I remember correctly. But the other side just has a single wire with a blade connection terminal not connected to anything. Can someone please tell me where this might go or is supposed to be hooked to.

Thanks all.

Sid
 
You must log in or register to reply here.

Jeep-CJ Donation Drive

Help support Jeep-CJ.com by making a contribution.

Help support Jeep-CJ.com by making a contribution.
Goal
$200.00
Earned
$40.00
This donation drive ends in
0 hours, 0 minutes, 0 seconds
  20.0%
Contribute
Back
Top Bottom