Members CJs 1980 cj7 v8
Just bought this cause it reminded me of the first one I owned 10 years ago. Needs alot of work but still looks good.
-
Hello Guest, we are proud to now have our Wiki online that is completely compiled and written by our members. Feel free to browse our Jeep-CJ Wiki or click on any orange keyword when looking at posts in the forum.
Members CJs 1980 cj7 v8
- Thread starter Noah12343
- Start date Start date:
- Last post Last post:
-
- Tags
- cj7 classic offroad project restoration
I accidentally posted twice haha. It said there was an error so I didn't know it worked.
TSB8C
Old Time Jeeper
- Posts
- 1,059
- Featured
- 11
- Media
- 26
- Resources
- 1
- Solutions
- 25
- Thanks
- 558
- Location
- Cut-n-Shoot, TX
- Vehicle(s)
- 1984 CJ7, 420 HP "ZZ6 EFI" Crate engine, 700R4, D300, Dana30 front, Dana489 rear, 4.56 gears, 4" lift
Nice. From that pic, the body looks in good shape (at least the front and passenger side
). Stout pipe bumpers and a V8 - nice. Keep us posted on your progress toward that "needs alot of work".
). Stout pipe bumpers and a V8 - nice. Keep us posted on your progress toward that "needs alot of work".It's leaking from everything but the engine so its gonna be slow fixing for sure haha.
I've already started on a big ignition tune-up. Coil, distributor cap, plugs, etc.
I honestly searched for a forum with old jeeps like this one cause the previous owner had the wiring and air lines EXTREMELY messed up.
It has a problem where it stutters and stalls under normal load if giving throttle anywhere between wide open to idle.
Has "newish" carb, fuel filter and pump look pretty new and gaskets were good. But the vacuum lines are roughly hooked up or missing lines along with factory wires just dangling out of the wire looms. I'm planning on replacing the wires and lines necessary to make it run properly but I don't know where anything goes yet.
I've already started on a big ignition tune-up. Coil, distributor cap, plugs, etc.
I honestly searched for a forum with old jeeps like this one cause the previous owner had the wiring and air lines EXTREMELY messed up.
It has a problem where it stutters and stalls under normal load if giving throttle anywhere between wide open to idle.
Has "newish" carb, fuel filter and pump look pretty new and gaskets were good. But the vacuum lines are roughly hooked up or missing lines along with factory wires just dangling out of the wire looms. I'm planning on replacing the wires and lines necessary to make it run properly but I don't know where anything goes yet.
TSB8C
Old Time Jeeper
- Posts
- 1,059
- Featured
- 11
- Media
- 26
- Resources
- 1
- Solutions
- 25
- Thanks
- 558
- Location
- Cut-n-Shoot, TX
- Vehicle(s)
- 1984 CJ7, 420 HP "ZZ6 EFI" Crate engine, 700R4, D300, Dana30 front, Dana489 rear, 4.56 gears, 4" lift
Well you found the right site. Plenty of knowledge and help available here.
