Clutch Bellhousing bolt size for the clutch pivot ball bracket
-
Hello Guest, we are proud to now have our Wiki online that is completely compiled and written by our members. Feel free to browse our Jeep-CJ Wiki or click on any orange keyword when looking at posts in the forum.
Clutch Bellhousing bolt size for the clutch pivot ball bracket
- Thread starter defibvt
- Start date Start date:
- Last post Last post:
TSB8C
Old Time Jeeper
- Posts
- 1,183
- Featured
- 12
- Media
- 26
- Resources
- 1
- Solutions
- 30
- Thanks
- 655
- Location
- Cut-n-Shoot, TX
- Vehicle(s)
- 1984 CJ7, 420 HP "ZZ6 EFI" Crate engine, 700R4, D300, Dana30 front, Dana489 rear, 4.56 gears, 4" lift
If you mean the bolt I circled here, I thought they were 1/4-20. But since I pulled all that and switched to an auto, I no longer have any of this hardware.
CJ
Admin
- Posts
- 26,038
- Featured
- 3
- Media
- 881
- Resources
- 193
- Solutions
- 60
- Thanks
- 1,055
- Location
- Central FL
- Vehicle(s)
- '72 CJ5, 401, T18, D20, D44, D30
'82 CJ8, 258, D300, AMC20, D30
Better get two 3/8-16 also. That's my recollection on the size but I may have drilled them out for strength. 
defibvt
Senior Jeeper
- Posts
- 763
- Thanks
- 7
- Location
- AZ
- Vehicle(s)
- 1974 CJ5, 4.0L stroker from a 91 XJ,T-18 w/ granny gear, Dana 300 w/ Lomax 4:1 gears.
Thanks for the heads up. I don't think the thread pitch is 16 butbi will keep a look out when go through my stash.
Sent from my SM-G965U using Tapatalk
Sent from my SM-G965U using Tapatalk
CJ
Admin
- Posts
- 26,038
- Featured
- 3
- Media
- 881
- Resources
- 193
- Solutions
- 60
- Thanks
- 1,055
- Location
- Central FL
- Vehicle(s)
- '72 CJ5, 401, T18, D20, D44, D30
'82 CJ8, 258, D300, AMC20, D30
That's and odd ball size but glad you have it worked out.
Similar threads
-
Question
Reply's are voted
on for best answer
Engine
Question about bolt size
-
Question
Reply's are voted
on for best answer
-
Question
Reply's are voted
on for best answer
Clutch
TO bearing "play"