Carpet Question
-
Hello Guest, we are proud to now have our Wiki online that is completely compiled and written by our members. Feel free to browse our Jeep-CJ Wiki or click on any orange keyword when looking at posts in the forum.
Carpet Question
- Thread starter Ruckus45
- Start date Start date:
- Last post Last post:
BusaDave9
Always Off-Roading Jeeper
- Posts
- 8,248
- Featured
- 3
- Media
- 361
- Resources
- 2
- Thanks
- 88
- Location
- Durango, Crawlarado
- Vehicle(s)
- 1979 Jeep CJ5 with 304 V8, T18 Transmission, Dana 20 Transfer case with TeraLow 3:1 gears, 4.88 axle gears, Detroit Locker up front and Ox Locker in back with 1 piece axle shafts, 36" SuperSwamper SX Tires, Shackle reversal, MileMarker Hydraulic winch, MSD 6A ignition.
bullseye
Active Jeeper
I think you are going to have some issues if you are looking for a clean install.
Depending on your kit, you could have 5 separate pieces of carpet to install.
The main problem I see is that you are going to have to cut through the finished edging. That might be fine for you and if so, cool.
The next issue I see is the molded front portion. I have a feeling that too is not going to fit right and you are going to have raised portions that don't sit well. Again, that might be just fine for you.
If you are getting it for next to nothing, then I guess it won't hurt to try?
Depending on your kit, you could have 5 separate pieces of carpet to install.
The main problem I see is that you are going to have to cut through the finished edging. That might be fine for you and if so, cool.
The next issue I see is the molded front portion. I have a feeling that too is not going to fit right and you are going to have raised portions that don't sit well. Again, that might be just fine for you.
If you are getting it for next to nothing, then I guess it won't hurt to try?
Ruckus45
Jeeper
- Posts
- 61
- Media
- 5
- Thanks
- 0
- Location
- Charlotte Area, NC
- Vehicle(s)
- 1978 CJ5 AMC304, 2011 JKU Sport (nothing awesome until warrenty is up)
I appreciate the help and especially the pics. Im not too worried about finished edges since I will be putting in a small speaker system that will cover anything I have to cut.
The back part should be easy, I am still unsure about the front. I really dont know how much of a difference the front of a CJ5 is to a CJ7 . Obviously the door opening is different, but how does that translate to the floor?
The back part should be easy, I am still unsure about the front. I really dont know how much of a difference the front of a CJ5 is to a CJ7 . Obviously the door opening is different, but how does that translate to the floor?