CJ7 / Chevy Drivetrain Question

[GravyProv1]

Ok, buddy of mine has a full custom build going. CJ7 , Chevy 350, 465 Transmission , 205 transfer, Dana 44 front/rear, Spring Over Axle.

Struggling to find front / rear driveshafts that fit for correct length and proper angle.

Anyone have this setup or know a good resource to solve problems?

Thanks,
Gravy

 

[jasonmark1993]

Well I used Tattons driveline service for my rear driveline when I did my swap.

I kept my front stock one; actually used it as a guide so I knew where to put the tcase.

Not sure you'll be able to do anything but get custom ones; or at least have the stockers lengthened/shortened to fit.

 

[Old Dog]

My front one is from Tom Woods and my rear is a cut down xj front shaft.

 

[Incommando]

My front one is from Tom Woods and my rear is a cut down xj front shaft.

Very common source for a CV- joint rear.

 

[GravyProv1]

Old Dog.. the Tom Woods idea is perfect.

They really have everything imaginable to fix his problem. Costly, but I'm sure it will end up a perfect fit and should not have any vibration issues.

Thanks again.

 

[jasonmark1993]

Id price check with Tattons driveline. He was cool and responded quick; got the driveline in a few days.

On the other hand, the guy at Tom Woods was kinda rude and short with me. Must have been isolated though because I have heard all good things about them.