D300 yoke speedi sleeve

[OEM1984CJ7]

Any one used a speedi sleeve for the yoke on a Dana 300 Transfer Case ? Not for a clocking ring but just on the drive shaft yoke. If so part #?

 

[CJ]

Never used one on a Dana 300 yoke but I have used them on dampeners. I think the part # is 99193 (the length will have to be trimmed as its made to be a shaft extension) but don't hold me to that. I would give them a call.

 

[CJ]

! You said the yoke not the input shaft! Please disregard...

Just mic out the yoke and give them a call, they can give you a part # for a sleeve, I cannot fin it in the catalogs I have.

-->> SPEEDI-SLEEVE Catalog

 

[OEM1984CJ7]

I think I found a yoke from a Dana 30 that is the same in my junk pile that is good. We will see.

 

[73CJ]

Had good luck with them on the dampers. (Front crank pulley).