Doors
oilfieldhand
Jeeper
Ok I have tried to search it but no luck. Were can I find parts to fix my doors? PO put in a wedge on the drivers side to hold up the window.
-
Hello Guest, we are proud to now have our Wiki online that is completely compiled and written by our members. Feel free to browse our Jeep-CJ Wiki or click on any orange keyword when looking at posts in the forum.To dismiss this noticeclick the top right X.
Doors
- Thread starter oilfieldhand
- Start date Start date:
- Last post Last post:
IOPort51
NOT the voice of reason Jeep-CJ.com
- Posts
- 13,956
- Media
- 458
- Thanks
- 11
- Location
- Garland Texas
- Vehicle(s)
- 1977 cj-5
4.2 W/MC2100 carb, 4.0 head W/3 angle valves,SS Header,TFI ignition with MSB-6 offroad module,CS144 140 amp RPS alternator with remote regulator T-150,d-20,Dana 44 with OX lock and disk brakes. D-30 with Spartin locker,
skyjacker 2.5 lift?nitro shocks,31" BFG A/T off road.8000 lb Warn winch, original owner.=^)
2006 Toyota Tacoma
have you taken it apart far enough to find out why it doesn't work?? Whats broken?
Ok I have tried to search it but no luck. Were can I find parts to fix my doors? PO put in a wedge on the drivers side to hold up the window.
oilfieldhand
Jeeper
have you taken it apart far enough to find out why it doesn't work?? Whats broken?
No u haven't yet I was hoping there was a place to find parts when I do
IOPort51
NOT the voice of reason Jeep-CJ.com
- Posts
- 13,956
- Media
- 458
- Thanks
- 11
- Location
- Garland Texas
- Vehicle(s)
- 1977 cj-5
4.2 W/MC2100 carb, 4.0 head W/3 angle valves,SS Header,TFI ignition with MSB-6 offroad module,CS144 140 amp RPS alternator with remote regulator T-150,d-20,Dana 44 with OX lock and disk brakes. D-30 with Spartin locker,
skyjacker 2.5 lift?nitro shocks,31" BFG A/T off road.8000 lb Warn winch, original owner.=^)
2006 Toyota Tacoma
you may get lucky and find you just need a little epoxy or a rivet.
DRoss
Jeeper
Had the same problem with mine from the PO. Took it apart and found the regulator arm twisted like a pretzel. Hammered it straight on a vise and put it back together. Works great.