fenderless rear tirewells

[fishinfool98]

so what do yall think, they still need a little work but there almost done

 

[CJ]

They look pretty good. Not much left to work out if you ask me!

 

[Petescj]

I like them. How much did you open it up?

 

[fishinfool98]

i cut the factory body line out and that was it then took a piece of 1 1/4 x 5ft angle and cut and bent it until i liked the way it looked
If you do it start in the center and measure the flat part of the top of the tirewell ( this part was around 15 1/2 inches) then make 3 inch cuts from there

I only made 2 cuts on each side then take the same thickness flat plate and cut the little peices to tack in but wait until the piece is tacked in place where you want it before you weld the small filler pieces in, or you will have to do it again

 

[essexmo]

so what do yall think, they still need a little work but there almost done

are you going to flare the fender to stop the mud covering everything as the tire looks to be jutting out a long way ???

 

[fishinfool98]

are you going to flare the fender to stop the mud covering everything as the tire looks to be jutting out a long way ???

The axels are dana 44s out of a scout 2 so they stick out farther
not reall worried about mud slinging up on the sides, much less am i going to be able to stop it with the larger sized tires

 

[essexmo]

The axels are dana 44s out of a scout 2 so they stick out farther
not reall worried about mud slinging up on the sides, much less am i going to be able to stop it with the larger sized tires

looks like its going to be a fun ride