Fuel line

[davey25]

How's this

 

[davey25]

Ok I'm doing a build but seems impossible to get a build thread on here..anyways quick question...I'm leaving the body on so while replacing my fuel line it's nearly impossible to bend the line over the shock mount..so I chose to use rubber from this point to the tank.also cleans up a bit better so I took it through the frame..going to put some protection at entry and exit point though..I've heard of vapour lock issues but Im still running the majority of the line as steel..anyone have any insight to what I've just done..thanks guys

 

[mtnwhlr]

That looks good to me. Have you submitted a build thread for approval?

 

[davey25]

Tried no response

 

[ThisGuyUKnow]

Ok I'm doing a build but seems impossible to get a build thread on here..anyways quick question...I'm leaving the body on so while replacing my fuel line it's nearly impossible to bend the line over the shock mount..so I chose to use rubber from this point to the tank.also cleans up a bit better so I took it through the frame..going to put some protection at entry and exit point though..I've heard of vapour lock issues but Im still running the majority of the line as steel..anyone have any insight to what I've just done..thanks guys

To get a build thread, you enter the forum and submit a new post just like you would any other forum, the thread wont immediately show up because it has to be approved by an admin.

Vapour lock, as I understand it, is caused by the lines getting hot enough to vaporize the fuel in the line. It is unlikely that a vapor lock problem would occur in the fuel line that far away from the engine.