How to install knob bezels
-
Hello Guest, we are proud to now have our Wiki online that is completely compiled and written by our members. Feel free to browse our Jeep-CJ Wiki or click on any orange keyword when looking at posts in the forum.
How to install knob bezels
- Thread starter 1984 CJ7
- Start date Start date:
- Last post Last post:
Old Dog
Always Off-Roading Jeeper
- Posts
- 13,880
- Media
- 82
- Thanks
- 6
- Location
- Stonelick Lake, Ohio
- Vehicle(s)
- 83 CJ7 350 tbi, TH350, D300 twin sticked & clocked, narrowed Chief D44 Eaton Elocker & Moser shafts, Explorer 8.8 Detroit locker, 410's, RE 4.5" spring lift 1" body lift, 35" Claws, cage tied to frame, Corbeau baja seats, HD tie rod and draglink, u-bolts flipped, custom skid plate and sliders, Warn 9.5ti winch with Amsteel synthetic line
the old ones just pull off (glued on) I think most of the new ones have a set screw to hold them on.
bullseye
Active Jeeper
The headlights, windshield wipers, and heater fan control knobs will just pull off. Those are the three that are missing knobs in this picture.
The other three knobs for heat, vent, and defrost are glued onto the metal of the cable. I removed mine using 2 sets of pliers. I held the metal cable with one and turned the plastic knob with the other. It will break the knob FYI.
The bezzle type replacements simply sit on the end of the cable and are held in place with a screw that you tighten.
The other three knobs for heat, vent, and defrost are glued onto the metal of the cable. I removed mine using 2 sets of pliers. I held the metal cable with one and turned the plastic knob with the other. It will break the knob FYI.
The bezzle type replacements simply sit on the end of the cable and are held in place with a screw that you tighten.
billyocup
Senior Jeeper
- Posts
- 662
- Thanks
- 6
- Location
- Arnold, CA
- Vehicle(s)
- 75 CJ5 304V8 T15 D20 D44 D30 2 1/2" lift, 05 Victory Kingpin, 2011 GMC Sierra 3500 Diesel 4x4
rbagley
Active Jeeper
- Posts
- 256
- Media
- 37
- Thanks
- 0
- Location
- Kalamazoo, MI
- Vehicle(s)
- 82 CJ7 w/258 I6 (Weber 38/38) de-smogged
5 speed manual BorgWarner trans
Dana 300 transfer case
Dana 30 front. AMC 20 w/lunchbox locker
Guys, I have the same question/request. I bought new knobs/pull cables and never kept track of which cable goes to which lever on the blower assembly.
Two of the cables are the same length. I know that the longest one goes to the furthest lever, but not sure if on the dash it goes to the air, temp or defrost.
Can you help me out? I posted pictures of the spots in the dash where they go, two of the closer levers, as well as the new cables themselves.
Similar threads
-
Question
Reply's are voted
on for best answer
-
Question
Reply's are voted
on for best answer
How do I?
‘83 CJ7 Heat troubles
-
Question
Reply's are voted
on for best answer
How do I?
Radiator Selection
-
Question
Reply's are voted
on for best answer
How do I?
Oil seal