Engine Intake manifold rust

[Sawjaws]

Sooo. I pulled off my carburetor today to rebuild it since I am waiting for a Transfer Case gasket kit. The carb (Holley 2300) could definitely use some TLC as well. Found this when I pulled it off. Am I pulling this intake off?? And then what? I bought a bore scope to inspect the cylinders. I am starting to worry about this motor. It sounded smooth when I bought it...

 

[Manic Mechanic]

I wouldn't worry about it unless it was giving you signs of not running correctly. If you want to bore scope it fine but don't sweat it. Or if you're worried about the intake put an aluminum one on it.

 

[Sawjaws]

I wouldn't worry about it unless it was giving you signs of not running correctly. If you want to bore scope it fine but don't sweat it. Or if you're worried about the intake put an aluminum one on it.

I will check the cylinders tomorrow and if they look good I will be able to breathe. Fingers crossed. Thanks!

 

[Belizean]

I will check the cylinders tomorrow and if they look good I will be able to breathe. Fingers crossed. Thanks!

I know what you mean.