New to Site
DE in IA
Jeeper
Hi all. Just registered for this site. I recently purchased a "Franken-jeep" and am trying to get it running. It appears from the research it is a 1945ish Willys MB but the motor serial number on the engine is for a CJ3a . It is an L 134 engine. It kinda ran when I got it but was real hard starting. I put in a new electronic distributer and coil, new solex carburetor and a new fuel pump. It had a old electric fuel pump on it that was full of sand so figured the fuel system was probably contaminated so decided to change out what I could.
I am pretty sure the distributer is in right as there is only one way to put it in with the slot. I have had another friend make sure the plugs wires are right.
I put a Holey pressure regulator on the fuel line and set as near as possible to 2 pounds but it still floods and fills the intake manifold with raw fuel.
Any thoughts or suggestions would be greatly appreciated.
I am pretty sure the distributer is in right as there is only one way to put it in with the slot. I have had another friend make sure the plugs wires are right.
I put a Holey pressure regulator on the fuel line and set as near as possible to 2 pounds but it still floods and fills the intake manifold with raw fuel.
Any thoughts or suggestions would be greatly appreciated.