Quadra-Trac
-
Hello Guest, we are proud to now have our Wiki online that is completely compiled and written by our members. Feel free to browse our Jeep-CJ Wiki or click on any orange keyword when looking at posts in the forum.
Quadra-Trac
- Thread starter Swilliams
- Start date Start date:
- Last post Last post:
Fastatv
Senior Jeeper
- Posts
- 612
- Thanks
- 0
- Location
- Whitesburg, TN
- Vehicle(s)
- 1976 CJ-7, 360 V-8, Turbo 400 trans, Quadratrac, Dana 30 up front, AMC 20 in rear with LOKKA locker, Otherwise stock...and rusty, but FUN!
Hi SW, I'm no expert but I can explain the basics. The Jeep QuadraTrac was designed to be a full time 4WD system. In the Normal mode, the jeep is in full time 4WD but the front axle and rear axle can turn somewhat independently of one another.....they do not have to turn at the same speed....there is some slippage between them. When you move the glove box mounted vacuum switch to the emergency mode, this basically locks the front and rear axles, resulting in a more aggressive 4WD. The QuadraTrac Transfer Case has what has been referred to as a mini differential inside. In normal mode, this diff slips, in emergency mode, its locked in. Hope this helps, Rick
Try this link....its here in the forum and provided by BusaDave I think. http://www.jeep-cj.com/forums/f105/transfer-cases-12108/
Last edited:
Peanut Butter
Full Time Jeeper
- Posts
- 2,591
- Media
- 37
- Resources
- 1
- Thanks
- 15
- Location
- Boerne, Texas
- Vehicle(s)
- 1979 Jeep CJ7 TH400 Automatic 258 I6 Quadratrac Amc 20 rear & Dana 30 front, 32 x 11.5 x 15 tires. Currently a Complete Custom Rebuild in progress.
Also I own a 2001 Jeep Cherokee, White, all stock with 4.0L. automatic, and police package. Best part of that is it came with leather seats! This package also has the NP242 Transfer Case, 8.25 rear end, and trailer towing package.
It's a lot like a locking differential. Unlocked (normal mode) power is divided as needed between the front and rear axles. Locked (emergency mode) power is divided equally between the front and rear axles. This does not however control the powere between wheels on each axle, that would require a locking differential of some type. It was the first attempt at full time 4 wheel drive. You will also find a gear reduction unit usually attached to these. This only reduces the gear ratio before the power goes to each axle. Have we totally confused you now? Rod
Saddle Tramp
Full Time Jeeper
- Posts
- 1,687
- Thanks
- 2
- Location
- Vancouver, USA
- Vehicle(s)
- 1978 CJ5, AMC 401, CJ T18, Scout Dana 300, 2-1/2" Lift, Locked
007
Crazy Sr. Respected Jeeper
- Posts
- 3,451
- Media
- 5
- Solutions
- 1
- Thanks
- 64
- Location
- Reno, NV
- Vehicle(s)
- 1977 CJ-7 Renegade (Daisy Jane), Levis trim, 304, TH400, BW1339 (MM), D30/Auburn Max, AMC20/Detroit/G2's, 4.88's, 33" BFG MT KM2's, Edelbrock Performer intake, Holley Sniper 4bbl EFI, MSD6, MSD ProBillet distributor, OME shocks, 4" ProComp lift.
The net result of this set up is no different than what's in my Ford Expedition. I have AWD / 4H / 4L. Works the same way with a QuadraTrac . These got a little bit of a bad name for one basic reason, very few people knew how to use them correctly at the time they came out. And even yet today people over complicate their usage. It's silly really. If you can operate one of today's four wheel drives you can operate a QuadraTrac . The only mechanical shortcoming they had was the chain drive. The system works great so long as you keep the right fluid in there and make sure that chain stays tight and replace it with gets too loose. The other mechanical problems come from people just not using it correctly or trying to bastardize the system.
Sent from my iPad using Tapatalk
Sent from my iPad using Tapatalk
Saddle Tramp
Full Time Jeeper
- Posts
- 1,687
- Thanks
- 2
- Location
- Vancouver, USA
- Vehicle(s)
- 1978 CJ5, AMC 401, CJ T18, Scout Dana 300, 2-1/2" Lift, Locked
Quality parts for the most part have dried up as Borg-Warner no longer supports them; Crown seems to be the only source.
