Raptor Touch Up
mdeluca
Full Time Jeeper
- Posts
- 1,771
- Featured
- 1
- Solutions
- 2
- Thanks
- 70
- Location
- Hickory, NC
- Vehicle(s)
- 1986 CJ7, 258, T5, D30, D44, D300
Here is a simple post.
I had a few places where the Raptor liner had popped off. These were less than the diameter of a pencil eraser. I didn't have any Raptor lying around so started poking around at what I did have. Did a little experimenting and this is what I came up with.
Wipe the area with some rubbing alcohol. Thin some GB liquid tape with Naphtha (not too thin). Then taking an acid brush trimmed as shown, dab the liquid tape on the bare area creating a stippled effect. It may take two or three applications.
The sheen and texture is near perfect.
I had a few places where the Raptor liner had popped off. These were less than the diameter of a pencil eraser. I didn't have any Raptor lying around so started poking around at what I did have. Did a little experimenting and this is what I came up with.
Wipe the area with some rubbing alcohol. Thin some GB liquid tape with Naphtha (not too thin). Then taking an acid brush trimmed as shown, dab the liquid tape on the bare area creating a stippled effect. It may take two or three applications.
The sheen and texture is near perfect.
