Steering Referral to a great Fabricator
- Posts
- 618
- Featured
- 4
- Media
- 135
- Resources
- 2
- Solutions
- 2
- Thanks
- 347
- Location
- Colorado
- Vehicle(s)
- 1986 CJ7 Laredo:
258 w/Howell TBI, HEI Ign., Dana 44 Front w/Detroit, Dana 44 Rear w/Discs & Detroit,
NP435 Trans, Dana 300 T-case w/twin stick
1969 Bronco:
351W, D44 high pinon front from full size, 9” full size rear, NP435 trans and Dana 20
I have been searching for a custom Tie Rod and Drag Link for another build of mine. Found this outfit out of Iowa, Extreme Custom Fabrication.
(Link)-> Steering Parts, Tie Rod & Drag Link Kits, Tie Rods, Reamers, 7/8-18 Taps, Nuts & Adapters, D.O.M. Tubing -<
Ordered the parts on Saturday. They confirmed the order on Sunday and asked for some measurements. I received the custom parts on Wednesday and shipping was free. Holy cow!
The parts look great and they're much cheaper than a couple others out there.
Definitely recommend Mike and these guys!
(Link)-> Steering Parts, Tie Rod & Drag Link Kits, Tie Rods, Reamers, 7/8-18 Taps, Nuts & Adapters, D.O.M. Tubing -<
Ordered the parts on Saturday. They confirmed the order on Sunday and asked for some measurements. I received the custom parts on Wednesday and shipping was free. Holy cow!
The parts look great and they're much cheaper than a couple others out there.
Definitely recommend Mike and these guys!
