starter bolts n bell housing to block bolts
bogger87cj7
Jeeper
Can anyone tell me the correct size of bolts needed for a starter and bell housing to block on a AMC 258 i6 / 4.2l motor and T-150 tranny?
-
Hello Guest, we are proud to now have our Wiki online that is completely compiled and written by our members. Feel free to browse our Jeep-CJ Wiki or click on any orange keyword when looking at posts in the forum.To dismiss this noticeclick the top right X.
starter bolts n bell housing to block bolts
- Thread starter bogger87cj7
- Start date Start date:
- Last post Last post:
Jimbos76cj
Full Time Jeeper
- Posts
- 2,223
- Thanks
- 1
- Location
- St.Cloud FL
- Vehicle(s)
- 83 CJ-7.. 4" YJ springs front rear, J-10 44 front/AMC 20 rear,6 cy auto dana 300 35' bfg Done and gone!!
Ask me about my head light upgrade harness!!!
I just swapped out tranny's on a 88 YJ with the 6 cyl.. top 2 should be 3/8-16 and middle 2 should be 7/16-18. Either way they are one of those 2 sizes
jasonmark1993
Old Time Jeeper
- Posts
- 1,366
- Media
- 10
- Thanks
- 2
- Location
- El Paso TX
- Vehicle(s)
- FJ cruiser (wifes ride)
2008 ZX10R,
73 CJ5, 408W, Toploader, Dana 20, 9" Dana 30 5.38 gears, next purchase=slicks
7/16 18 is a common automotive size but rarely carried at big box stores like lowes or homies.
I found them bulk at a smaller hardware store or two in a little rip off box at Autozone.
I found them bulk at a smaller hardware store or two in a little rip off box at Autozone.