• Hello Guest, we are proud to now have our Wiki online that is completely compiled and written by our members. Feel free to browse our Jeep-CJ Wiki or click on any orange keyword when looking at posts in the forum.

Waterproofing in-line fuel pump?

Waterproofing in-line fuel pump?

Joebronco

Jeeper
Posts
210
Thanks
0
Location
Dublin, CA
Vehicle(s)
1984 cj7, 4.0/4.2 head swap, EFI, T5, D20/44, JY MPI
I did the AMC 258 i6 / 4.2l head and FI swap a while back. I added the in-line E 2000 fuel pump.

I'm getting ready to do a run with a few friends and it occurred to me that the pump will be submerged in water at least once during the trip.

how would I be able to waterproof the pump? I assume the electrical will short. I've always had in tank pumps.


Sent from my iPhone using Tapatalk
 
Start by packing all electrical at the FP with dielectric grease.
Carry a spare FP just in case.
LG
 
Start by packing all electrical at the FP with dielectric grease.

Carry a spare FP just in case.

LG



Always got a spare. ;)

But I would like to avoid it. Have you ever sealed up electrical with that plastic dip stuff?


Sent from my iPhone using Tapatalk
 
I have used liquid electrical tape with very good results.
Clean with alcohol before applying.
LG
 

Jeep-CJ Donation Drive

Help support Jeep-CJ.com by making a contribution.

Help support Jeep-CJ.com by making a contribution.
Goal
$200.00
Earned
$0.00
This donation drive ends in
0 hours, 0 minutes, 0 seconds
  0.0%
Back
Top Bottom