Where does this fit?
-
Hello Guest, we are proud to now have our Wiki online that is completely compiled and written by our members. Feel free to browse our Jeep-CJ Wiki or click on any orange keyword when looking at posts in the forum.
Where does this fit?
- Thread starter Captainlance
- Start date Start date:
- Last post Last post:
Belizean
Always Off-Roading Jeeper
- Posts
- 6,550
- Featured
- 1
- Media
- 20
- Solutions
- 2
- Thanks
- 572
- Location
- New Orleans area
- Vehicle(s)
- 84 CJ7 4 banger-owned since new in 1984 bought off truck at dealership - rebuilding 258, T176 with Sniper EFI D300 4:1 Lomax gears Twin Sticked 1 piece axels with locker
I don't recognize them at all. I don't have a hard top. So maybe there? Sure never seen them on mine. Never taken mine down to the frame though but have been all over it!
Torxhead
Always Off-Roading Jeeper
It is used to cover the tail light harness and fits behind the driver's seat against the body.
- Posts
- 14,790
- Thanks
- 55
- Location
- Springfield, Missouri-U.S.A. Earth
- Vehicle(s)
- '85 CJ-7, 258/4.2L 6cyl. Bought new in 1985. Full cage, Warn 8274 winch, Ford 9" rear, front/rear Detroit Lockers w/4:88 R&P. T-5 tranny and 4:1 t'case. 33X12.50-15 BFG/AT, MSD ign, on board air---
The top piece in the picture is the piece that goes off the bottom corner of the D/S door.
The other is fitted higher up in the door's chanel.
You should have screw holes in the body to confirm fitment.
LG
Belizean
Always Off-Roading Jeeper
- Posts
- 6,550
- Featured
- 1
- Media
- 20
- Solutions
- 2
- Thanks
- 572
- Location
- New Orleans area
- Vehicle(s)
- 84 CJ7 4 banger-owned since new in 1984 bought off truck at dealership - rebuilding 258, T176 with Sniper EFI D300 4:1 Lomax gears Twin Sticked 1 piece axels with locker
Sho-nuff. Only the bottom one in the picture is longer on mine