Build Thread 1986 CJ-7 Laredo ALL NEW but the sheet metal...

[Longslyde]

@Belizean It's gonna be my dailly go-getter when it warms up again. She'll get dirty soon enough lol!

 

[Belizean]

@Belizean It's gonna be my dailly go-getter when it warms up again. She'll get dirty soon enough lol!

I remember those days, barely, over 41 years ago. I still love mine just as much.

 

[Longslyde]

Still working on all the ticky-tack stuff before carpet goes in. Replace the stub shaft in the short throw shifter to move the stick close to the drivers side. This stub moves the lever over 2" and back an inch. Gained just about another inch to the left by mounting the stick on the other side. So it ended up moving about 3" to the left and 1" back. MUCH better reach on it now. Here some before and afters...

 

[Longslyde]

Tested part of the sound system today. Only 2 dash speakers and a sub in open air right now to make sure all the connections were good and the head unit worked. Got 2 6x9's to add yet and make a console to fit the sub with some storage if theres room...

View attachment 20251214_135811.mp4

 

[muzhunter]

Longslyde,

Could you please post a PIC/PICS of the exhaust on the pass side back?

I need to install one on mine, currently just the stock manifolds (want headers) are in place. Concerned with the fuel lines running on pass side.

Muz

 

[Ratpack]

Mounted the exhaust tonight. Could get an X-Pipe in and was worried it would be too loud, but this sounds perfect to me. Even got full a full approval on the sound from the wife!
View attachment 105719View attachment 105720View attachment 105721
View attachment 105722

Sweet !

 

[Longslyde]

Got the rear interior mostly buttoned up tonight. Installed the carpet, seat, seat belts, and speakers.

 

[Longslyde]

Test fitting front carpet and cable routing before final seat install. THEN, it's on to see what I can make for a custom console.


Had to remake the seat adjuster handles for the wider seats...


Getting closer!

 

[Longslyde]

Getting more interior stuff done, made new seat mount to move the wider seat over. Got the shift levers set. Now to make some custom boots!

 

[Belizean]

Some fancy hardware you have !

 

[KRUPP]

Some fancy hardware you have !

Some bling there, for sure.

The CJ is turning out very nice.

 

[Longslyde]

Working on the boots now... Never even looked at sewing machine before I attempted this, so forgive the sloppiness.... It should do what it's supposed to though!

 

[Belizean]

Nice needle work. I’ve attempted that a couple of times. Lucky for me someone makes some good ones I can buy now.

 

[Longslyde]

NICE! I looked at that boot setup but my shifters don't line up the same as the Dana 300 . I'm sure the TR-4050 throws that off some too. The boot patterns are what I'm going for though. I have to make a new stainless boot ring too because my Transfer Case shifters location seems to be further out than most....